Fabrication
The parts the system needs, cut in Vaughan.
The CNC center is here for one reason: data-center HVAC needs components that are specific to the hall. SURPASS TECH INC. machines those parts on an AES CNC FLEXA PRO at 45 Bowes Road.
Machining center
AES CNC FLEXA PRO
Sheet components sit on a vacuum bed — zoned holding, fed by two vacuum pumps — while servo-driven axes follow the drawing. Rack-and-rail motion and a central lubrication system keep the cutting accurate and the machine maintainable.
- Machine
- AES CNC FLEXA PRO
- Workholding
- Enhanced vacuum zones and two vacuum pumps
- Motion
- Servo motors on a rack-and-rail system
- Lubrication
- Central lubrication system
- Dust collection
- Industrial collector rated at 4,600 CFM
The collector clears fines at the machine so cutting stays on the part, and the floor stays clear.
What gets cut
Components for the systems we design.
-
01
Panels
Faces, close-offs, and other sheet parts that have to match an opening in the hall.
-
02
Transitions
Turns and size changes that take the air from the equipment to the aisle.
-
03
Plenums
Chambers that collect or distribute air where a straight run will not.
-
04
Frames
Supports that hold a component on the line the drawing sets.
-
05
Blanking
Panels that close gaps so supply air reaches the equipment face.
-
06
One-off pieces
Any other component the HVAC design needs, dimensioned for that room.